Full 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Before
After
Before
After
Before
AfterTrusted Garage Door Parts for McDonough Homeowners
A garage door has roughly 90 moving parts, and when one fails in McDonough, the whole system usually stops working. We stock McDonough Garage Door Parts for every common failure. We replace them, and we show you the failed part before we quote anything. Servo Garage Doors has operated in McDonough since 2015, and every parts job starts with the same thing: a technician photographs the worn roller, the snapped cable, the split bottom seal, and then hands you a written price before any work begins. That’s Clause 4 of The Haven Standard, and it’s the reason homeowners in Henry County call us instead of rolling the dice on a phone estimate. If your door is stuck, loud, or sagging, call (470) 928-4767. We answer live, 24 hours a day.
Key Takeaways
- Garage door parts in McDonough carry written, flat price ranges before any work starts. No “call for quote” games.
- Spring repair runs $180-$340, cable repair $130-$250, roller replacement $110-$220 in this market.
- Every parts visit includes a documented photo record of what was found and what was replaced.
- We stock OEM parts for LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor.
- The 365-Day Done Right Promise backs every parts replacement we perform in McDonough.
- Parts are quoted, then replaced. Price quoted and agreed before any work starts. Always.
What Our Garage Door Parts Service Includes
We don’t do “general tune-ups” where you get a vague invoice at the end. We name the part, show you the part, price the part, and replace the part. Here’s what that looks like for each component we handle in McDonough.
Torsion Spring
A torsion spring is the coiled steel shaft mounted above your door that counterbalances its weight, and it’s the most common failure we see in McDonough garages. When it snaps, you’ll hear a bang that sounds like a firecracker in the next room, and the door won’t lift even with the opener running. We measure the old spring’s wire diameter, inner diameter, and length on site, then match it to a replacement rated for your door’s exact weight. The failed spring gets photographed and shown to you before we quote. In McDonough, torsion spring replacement on a standard two-car door typically runs $180-$340, installed.
Extension Spring
Extension springs run along the horizontal tracks on either side of the door, stretching to store lifting energy. Older McDonough homes with one-piece doors or lightweight aluminum doors often still use this design, and the springs fatigue gradually rather than snapping clean. You’ll know they’re tired when the door starts feeling heavier than it used to or begins dropping too fast when you release it. We inspect both springs, pulleys, and safety cables as part of any extension spring quote because the failure of one side almost always means the other is close behind. The price range for extension spring replacement in McDonough matches torsion spring work: $180-$340 for the pair.
Cables & Drums
Lift cables are the steel wires running from the bottom brackets of your door up to the drums at the top, and they carry the entire lifting load whenever the door moves. A frayed cable in McDonough’s humidity is a warning sign you shouldn’t ignore, because once it snaps, the door can drop unevenly and damage the track or the panels. Drums are the grooved spools that wind and unwind those cables, and when a drum wears, the cable stacks unevenly and accelerates wear. We replace cables and drums as a set when the wear pattern calls for it, and your photo record will show you the fraying before we touch anything. Cable repair in McDonough ranges from $130-$250.
Rollers & Hinges
Rollers are the small wheels that ride inside the vertical and horizontal tracks, and McDonough homeowners with doors over 8 years old are usually running steel rollers with worn bearings or nylon rollers with flat spots. A loud, grinding, or chattering door usually points here first. Hinges connect the door panels and hold the rollers in place, and when a hinge cracks from metal fatigue, that panel binds and stresses everything around it. We replace rollers in sets, not onesies, because a single new roller next to six worn ones just shifts the wear. Roller replacement in McDonough runs $110-$220, and hinge replacement is typically quoted in the same visit at the same time.
Weatherstripping
Weatherstripping is the vinyl or rubber gasket that seals the outside edge of your door opening, and in McDonough it takes a beating from summer heat, winter cold snaps, and the red Georgia clay that finds its way into every track. When it’s cracked, daylight shows through the gaps, and your garage becomes a corridor for drafts, bugs, and water. We replace perimeter weatherstripping, the J-channel that holds it, and any damaged door stops in the same visit. It’s the least expensive parts job we do, and it pays for itself the first time you skip a cold garage in January.
Bottom Seal
The bottom seal, sometimes called an astragal, is the rubber strip attached to the bottom of your door that compresses against the slab when the door closes. McDonough slabs shift, rubber cracks with age, and once that seal splits, water from the afternoon thunderstorms seeps under the door and leaves a tide line on your floor. We replace bottom seals with a U-shaped retainer matched to your door’s manufacturer, not a generic strip that falls out in two months. Bottom seal replacement is quick, inexpensive, and usually done while we’re already on site for another repair, which is when we’ll show you the split in the old one.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
BeforeAfterBrands We Service for Garage Door Parts
We service all eight major brands, including Craftsman, Raynor, LiftMaster, and Chamberlain. For Craftsman units, the most common parts failures we see in McDonough are logic boards that stop responding and limit switches that drift out of calibration, causing the door to reverse mid-travel. We carry OEM Craftsman parts on the truck or source them same-day from our local suppliers, and we photograph the failed board before quoting the replacement.
Raynor doors have a different track profile than most residential brands, and the rollers and hinges aren’t interchangeable with off-the-shelf hardware from a big-box store. If you have a Raynor, we make sure the parts we install match the manufacturer’s spec rather than whatever fits. LiftMaster and Chamberlain share a platform, but their gear-and-sprocket assemblies and wall consoles are not always cross-compatible across model years, and we know which is which. Whether you have one of those brands or anything else, we can supply and install the correct part.
Signs You Need Garage Door Parts Right Now
- Your door makes a loud bang and then won’t open. That’s a torsion spring snap, not a coincidental noise. Failing to address it means the opener motor strains against a dead spring and burns itself out, turning a $180-$340 part replacement into a $120-$320 opener repair on top of it.
- The door opens a few inches and stops, or reverses without hitting anything. Your limit switches or safety sensors have drifted or failed. A technician can diagnose it in minutes, but ignoring it leaves the door unreliable and creates a false sense of security at the worst possible moment.
- You can see frayed steel on the cables running up the sides of the door. A cable with broken strands is already past its service life. When it parts under tension, the door drops unevenly, and the panel damage alone can cost $250-$500 to correct.
- The door shudders, shakes, or sounds like metal on metal when it moves. Rollers with worn bearings don’t roll, they slide and chatter. Every cycle accelerates wear on the hinges, the track, and the motor, and a $110-$220 roller set is cheaper than the downstream repairs.
- You see daylight under the door or water stains on the concrete after rain. The bottom seal has failed, or the weatherstripping has lost its compression. McDonough’s afternoon storms will keep finding that gap until it’s closed, and the floor will keep paying for it.
Our Garage Door Parts Process - Step by Step
We built this process because Marcus Deller, our owner, was tired of the phone-quote-then-blame-the-customer model that dominated garage door repair in Georgia. The Haven Standard puts it in writing, and it works like this:
- 1
You call, a person answers. We pick up live at (470) 928-4767, 24 hours a day, and we ask what the door is doing, not what you think the part is. You’ll get a named technician and an on-the-way text, not a four-hour window.
- 2
We arrive and inspect the system, not just the symptom. The technician runs the door through a full cycle, watches it under load, and photographs the failed component before touching anything. That photo is the evidence you see before you approve any work, and it’s Clause 4 of The Haven Standard in action.
- 3
You get a written price for the specific parts and labor, before any work starts. We quote a flat number, not a range that expands when the invoice comes. The scope says what gets replaced and why. Clause 1 of The Haven Standard means ‘call for a quote’ is not how this works.
- 4
We replace the parts with correct-spec components. That means OEM where OEM is right, correct-gauge wire on springs, correct track profile on rollers, correct retainer on bottom seals. We don’t install whatever’s cheapest on a shelf and call it an upgrade.
- 5
You receive a documented photo record of before and after. The failed part, the new part installed, and a written warranty for the work. If anything isn’t right within 365 days, the 365-Day Done Right Promise means we make it right. No fine print, no phone tag.
How Much Does Garage Door Parts Cost in McDonough?
Here’s the pricing breakdown we use in McDonough. These are flat ranges, quoted in writing before any work starts:
| Parts Service | Typical Range |
|---|---|
| Spring repair (torsion or extension) | $180 – $340 |
| Cable repair | $130 – $250 |
| Roller replacement | $110 – $220 |
| Opener repair | $120 – $320 |
| Track realignment | $120 – $240 |
| Panel replacement | $250 – $500 |
| Bottom seal or weatherstripping | $80 – $180 |
What moves the price within these ranges comes down to three things: whether the part is standard or requires manufacturer-specific components, whether the door is a single-car or heavier two-car model, and whether anything else is worn and worth replacing at the same time. A single torsion spring on a lightweight door sits near the bottom; a pair of high-cycle springs on a 16-foot door sits near the top. The way to avoid overpaying in McDonough is to get the failed part photographed and the price in writing before you approve anything, and to bring a competitor’s written estimate to us for a free second opinion whenever you want a check. Your estimate is free, the photo record is included, and the price we quote is the price you pay.
Garage Door Parts Near McDonough - Our Service Area
We serve McDonough and the surrounding Henry County communities, with technicians dispatched daily to Hampton, Locust Grove, Stockbridge, Lovejoy, Irondale, Jonesboro, Morrow, Griffin, Riverdale, Forest Park, and Fayetteville. Most parts replacements in McDonough proper get same-day service, and we respond to emergency calls, like a snapped spring on a holiday, around the clock. If your garage door has failed and you’re reading this from anywhere in the area, call (470) 928-4767 and a person will pick up.
Serving McDonough, GA - Our Local Coverage Area
We’re based in the McDonough area and know this community well, and we also supply Garage Door Parts in Covington. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
Frequently Asked Questions - Garage Door Parts in McDonough
We replace every wear component on a residential garage door: torsion and extension springs, lift cables, drums, rollers, hinges, weatherstripping, bottom seals, brackets, limit switches, and opener components like gears, logic boards, and trolley carriages. We also carry our Garage Door Parts in Locust Grove and surrounding areas. If it’s on your door or in your opener, we can source it and install it. We stock most common parts and get uncommon ones from local suppliers same-day.
Most parts replacements take between 30 minutes and 2 hours once we’re on site. A single spring replacement is typically done in under an hour, while full roller and hinge overhauls run closer to 90 minutes. You get a time estimate as part of the written scope before we start.
Parts replacement in McDonough ranges from $80 for a bottom seal up to $500 for a panel replacement, with spring work in the $180-$340 range and cables at $130-$250. We also deliver Garage Door Parts - Stockbridge and nearby communities. The price depends on the specific part, your door’s size and weight, and whether anything else is worn alongside it. You’ll never hear a range that expands later: the written price we quote is the price you pay. Call (470) 928-4767 and we’ll tell you what it is, in writing, before any work starts.
Yes. We service LiftMaster, Chamberlain, Genie, Craftsman, Raynor, Clopay, Amarr, and Wayne Dalton equipment in McDonough. We carry OEM logic boards, gears, wall consoles, and safety sensors for the most common LiftMaster and Chamberlain models, and we’ll show you the failed board before we quote the replacement.
We answer live 24/7 and dispatch technicians to McDonough for same-day and emergency parts failures, including snapped springs on weekends and holidays. A torn cable on a Sunday is not something you wait until Monday to address. Call us and you’ll get a named technician and an on-the-way text.
Every parts replacement we do is covered by the 365-Day Done Right Promise: if the repair isn’t right, we make it right. The work carries a written warranty, and you’ll receive documentation of exactly what was installed. We’re independently owned and operated under The Haven Standard, and we stand behind our work in writing, not on a handshake.
Clear the area around the door so we have working room, move vehicles out of the garage if possible, and be ready to describe what the door is doing: when it started, what it sounds like, whether it stopped suddenly or gradually. You don’t need to have any parts on hand or know the diagnosis. That’s our job, and we’ll show you the evidence before you pay for anything.
Schedule Your Garage Door Parts Service in McDonough Today
If your door is loud, stuck, or leaking daylight through the seals, call (470) 928-4767 now. We’ll put a technician on it, show you the failed part, and quote a written price before any work starts. That’s how we’ve handled every garage door since 2015, and it’s how your repair will go. The estimate is free, the photo record is included, and the price is agreed before we touch your door.
Written by Marcus Deller, Owner at Servo Garage Doors McDonough, serving McDonough since 2015.